Victory Riders Network

The online community for riders & enthusiasts of Victory Motorcycles

Near straight drag bars, without risers, clamp straight into standard risers on my Hammer. At this stage, black or chrome and im thinking about 36 inch wide or there abouts. Need to be 1 inch dia in the obvious places. Im thinking ill have to retro fit something, as Victory does'nt seem to have what i want.

Regards,

Tim

Views: 27

Comment

You need to be a member of Victory Riders Network to add comments!

Join Victory Riders Network

Comment by Tim Gillon on February 13, 2013 at 4:13am

POSITION IS AWESOME AND LOOKS BLOODY TUFF. The Hammer should always have had something like this for bars. Ill post some picks so you ca gander.

Cheers

Comment by Tim Gillon on February 13, 2013 at 4:06am

Stop looking everyone. i had a set of drag bars made today. Wasn't easy finding the right size tube. Tube is sized by the inside diameter, so a near impossible task to find tubing that measured 1inch outside diameter. Had to make with heavy wall and very slightly undersize on the od. clamped up just fine. Maybe a tad wide though, 98 cm wide, without the end caps so with them on, thats over a meter. that'll make lane slitting hard lol. Can easliy sorten them if needed. POSITION IS AWESOME 

ME AND LOOK BLOODY TUFF.

Cheers everyone on your very helpfull feed back

Events

Victory Riders on Facebook







Follow The Victory Riders Network on Twitter



Get notification of the latest activity happening on the Victory Riders Network or any of the model specific sites in one place.
www.twitter.com/vrnetwork

 

Members

© 2020   Created by Victory Riders.   Powered by

Badges  |  Report an Issue  |  Terms of Service